POEX0100

10/100 PoE extender

PoE (IEEE 802.3af) and PoE+ (IEEE 802.3at) compliant

Extension up to 600 m (1968.5 ft) using 5 GV-POEX0100

Compatible with GV-IP Cameras

No additional power supply required
 

GV-POEX0100 is a single-port, 10/100 PoE extender that can extend the distance between a PoE switch and a GV-IP Camera by 100 m (328.08 ft) for every extender installed. They can be serially connected, with no additional power supply, to transmit power and data to a GV-IP Camera as far as up to 600 meters (1968.5 ft) away from a PoE switch.

GV-IP Cameras Powered by PoE

Note:

1. Each GV-POEX0100 extends another 100 m (328.08 ft) between the PoE switch and the GV-IP Camera. Therefore, a distance of 200 m (656.17 ft) requires one GV-POEX0100 and 400 m (1312.34 ft) requires three etc.
2. GV-POE0100 can only be connected using CAT-5e cables, TIA/EIA-568-B, with the maximum DC resistance of 9.38 ohms/100 m.

GV-IP Cameras Powered by Power Adapters

The maximum distance allowed between a PoE switch and a GV-IP Camera depends on the PoE switch type, PoE power output of the connected device (PD) and the type of power supply.

GV-POEX0100 is only compatible with third-party switches that comply to PoE+ (IEEE 802.3at) and is not compatible with GV-PA191/481/482/901.

GV-POEX0100 supports all GV-IP Cameras when installed with a power adapter and does not support the following models when powered by PoE:

GV-BX2510-E / 5310-E
GV-FE3403 / 5303
GV-VD2540-E / 5340-E
GV-SD220 / 220-S

GV-POEX0100 is only compatible with the following GeoVision PoE switches of the indicated firmware versions:

GV-POE0801 / 1601 / 2401 (V1.03 or later)
GV-POE0811 / 1611 / 2411 (V1.01 or later)